Front:
- Pannier support area: 781 cm² (121 in²) per side
- Rack width: 178mm outside to outside
- Weight: 1.34 kg (2.95 lb) with all the bolts and hardware as set up on a Long Haul Trucker
- Height: Adjustable to accomodate 26” to 29” wheels
- Tubing diameter: 10mm
- Tubing: 100% 4130 cro-moly tubing, two thicknesses throughout rack
- Hardware: all stainless steel bolts, nuts, washers and attachment plates, aluminum spacers
- Load weight limit: 32 kg (70 lbs)
- Surface finish: phosphate coated inside and out, powdercoated exterior
Rear:
- Pannier support area: 616 cm² (95 in²) per side
- Rack width: 160mm (6.3 in.) outside to outside
- Weight: 1.11 kg (2.45 lb.) with all hardware and bolts
- Height: Adjustable to accomodate 26”, 700c and 29” wheels
- Tubing diameter: 10mm
- Tubing: 100% 4130 cro-moly tubing, three thicknesses throughout rack
- Hardware: all stainless steel bolts, washers, tubing pieces and castings
- Load weight limit: 36 kg (80 lbs)
- Surface finish: phosphate coated inside and out, powdercoated exterior
Care and feeding of your Nice Rack:
- Although the Nice Rack has been phosphate coated inside and out and powdercoated on the exterior to protect it from the elements, it’s a good idea to coat the innards with a rust inhibitor like J.P.Weigle’s framesaver, boiled linseed oil or engine flogging spray. This will certainly prolong the life of your rack, as it would your steel frame
- Secure pannier bags onto the rack so that they don’t move around and create thin spots in the powdercoat. Over time, the powdercoat on your rack may develope thin spots from normal wear and tear. Before you wear it down to bare metal, it’s a good idea to touch up these spots with some good spray primer and paint, some brush-on car touch up paint and/or wrap it up with some electrical tape in these hot spots
